SMG/K FA20 T=1.0

STOPPER TYPE HEAD GASKET | TOYOTA | Explanation of the product | Application chart |
TOYOTA |
![]() |
Code No. 23001-AT004
|
0.5mm, 0.7mm, and 1.0mm thick bore stopper type metal head gaskets are available for the FA20 engine of 86 & BRZ. This gasket provides higher bore sealing durability than stock.Use with HKS Capacity Upgrade Kit or Supercharger Kit provides the optimum performance.
|
Compression Ratio
※These are design calculation ratios. |
Features
<POINT-1> Maintain high seal with high power!
All three types are durable against the high engine output. Stopper structure of the bore seal is designed to be a separated type to prevent leakage even under high gas-pressure at high engine output.
<POINT-2> Contact surface pressure is improved!
Special coating was applied on the head and cylinder side to improve sealing performance when tightening the bolts.
With t=0.5mm gasket, NA engine’s compression ratio increases compared with the stock!
The durability of the bore seal of this gasket t=0.5mm for NA engine is improved, and the compression ratio increase compared with the stock that makes this gasket ideal for one-make race. (This gasket can be installed to a supercharged engine.)
t=0.7mm for Supercharged Engine
The t=0.7mm type utilizes a stopper taller than the t=0.5mm type to provide higher bore seal durability. With a stock pistons, the compression ratio is reduced only by 0.1; it allows to maintain high heat efficiency.
t=1.0mm for HKS Capacity Upgrade Kit + Supercharger
Installing the t=1.0 type gasket to a vehicle with the supercharger enables to adjust the compression ratio of Capacity Upgrade Kit; setting range can be widened.
Engine | Thickness (mm) | Compression Ratio | Bore | Code No. | Price | Remarks |
---|---|---|---|---|---|---|
FA20 | 1.0 | ε=11.7 | φ89.5 | 23001-AT004 | For supercharger engine, LH/RH each, opposed bead stopper type |
[ CLOSE ]